Název

AUDIO LOT СHALLENGE GU-80 Single Ended amplifier

Popis

Vacuum tube single -ended tube amplifier GU-80

The amplifier combines two separate modules – for the left and for the right stereo channels.

Each module implements an amplifier stage built using a vacuum tube 6Э6П-ЕВ ( e810cc , D3a ) and a 300V voltage converter, which in turn supplies operational voltage to the output tube GU-80.

The input of every module is routed to its RCA input connector, and its volume control. The input sensitivity of the amplifier is sufficient to directly accept the input signal from either a turntable or a pre-amplifier.

The rear panel of the amplifier includes two connectors. They are used to set supply current to the output vacuum tube (240mA). To control the output current, a multi-turn potentiometer is accessible from the rear panel. To adjust the current, a small flat screwdriver should be inserted into an access slot in the rear panel.

The built-in power supply provides the normal operation from the line voltage in the range of 170 to 265VAC. The power supply has an overvoltage detection and protection: if the line voltage exceeds the nominal value, the protection circuitry automatically shuts down the amplifier.

The wide range of the line voltages is made possible by use of a proprietary microcontroller-based circuitry, which monitors the line voltage, and automatically selects the proper tap of the power transformer. Thus, the power transformer configuration is automatically aligned with the input AC voltage, assuring its optimal operation.

Specifications:

Configuration: Single module - mono block

Nominal power 100W at 5 Ohm load.

Frequency range 16Hz to 50kHz.

Output impedance 0.5 Ohm

Input impedance (L-type regulator) – 18 to 32kOhm, adjusted by regulator

Power consumption – 400W

Line voltage 170 to 265 VAC

430 х 500 х 320 Dimetions (mm)

Weight - 46 (kg)

Warnings!!!

1. Vacuum tube GU-80 is hot when operated, keep out of reach of children and pets! Avoid a direct contact with skin!

2. Vacuum tube GU-80 operates at a high voltage, keep out of reach of children and pets! Avoid a direct contact with skin!

3. Do not replace vacuum tubes during operation! To replace a vacuum tube, power down the amplifier, and wait a few minutes for the tube to cool down.

4. Do not power up the amplifier when vacuum tubes are not properly installed! It would cause damage of the amplifier circuitry.

Nastavení